User manual

- BaseWall VPN 6000 user manual -
1.5 Basic screen layout
Once you have logged in to the firewall's management interface, you should
see the following welcome screen.
The firewall has two modes of operation. One shows the current status of the
firewall and one is for configuration.
A red area in the upper left-hand corner of the screen indicates we are looking
at the “Current Status”(1) of the firewall. Tabs labeled “CONTROL”(2),
“NETVIEW”(3), “LOGS”(4) and “STATISTICS”(5) provide access to other screens
in the “Current Status” context.
The system status on the left hand side of the screen, about half-way to the
bottom displays some statistics concerning the operation of your firewall's
hardware. These statistics are updated once every 10 seconds, to insure the
accuracy of the information.
Pushing the Configuration button switches the interface into configuration
mode. The configuration is not directly activated. When witching back to
“Current Status” or pushing “Unapplied changes” button changes the actual
configuration of the firewall.
Page 16 / 79