Specifications
Table Of Contents
- About This Document
- Understanding Networking and IP Addressing
- Introduction to Networking
- Networking using IP
- Niagara Considerations
- Additional Information
- Configuration and Troubleshooting Tools
- Connecting on a LAN
- Connecting with Direct Dial
- Connecting to an ISP
- Using Security Technologies
- Configuration Files Used for Communication
- Glossary
- Index
Chapter 2 Configuration and Troubleshooting Tools
Niagara Configuration Tools
Niagara Release 2.3
Niagara Networking & Connectivity Guide Revised: May 22, 2002
2–11
Figure 2-7 VxWorks boot.
You see a prompt similar to the following:
[VxWorks Boot]:
You are connected to the target shell and it is ready for command input.
Step 14
When finished typing commands at the command prompt, follow the next procedure
to disconnect from the JACE.
Procedure 2-6 Disconnecting from the JACE when using Hyperterminal.
Step 1
Press the Disconnect button on the Hyperterminal tool bar.
Your session is disconnected from the JACE.
Step 2
Close the application by choosing File > Exit to exit the Hyperterminal application.
Step 3
Remove the jumper from the JACE-4/5.
Step 4
Reboot the JACE by removing the power connector, waiting for all lights to
extinguish, and plugging the power connector back in.