Specifications
Table Of Contents
- About This Document
- Understanding Networking and IP Addressing
- Introduction to Networking
- Networking using IP
- Niagara Considerations
- Additional Information
- Configuration and Troubleshooting Tools
- Connecting on a LAN
- Connecting with Direct Dial
- Connecting to an ISP
- Using Security Technologies
- Configuration Files Used for Communication
- Glossary
- Index
Chapter 2 Configuration and Troubleshooting Tools
Niagara Configuration Tools
Niagara Release 2.3
Niagara Networking & Connectivity Guide Revised: May 22, 2002
2–9
Step 2
Open Hyperterminal as follows:
• On Windows NT—Click Start then choose Programs > Accessories >
Hyperterminal > Hyperterminal
• On Windows 2000—Click Start then choose Programs > Accessories >
Communications > Hyperterminal
Step 3
In the Connection Description dialog box, type a name for this session. For
example:
Direct connect to JACE
Step 4
Click OK.
Step 5
In the Connect to dialog box, choose either COM1 or COM2, depending on which
serial port the null modem cable or adapter is attached to on your PC.
This makes the remaining options on the dialog box unavailable.
Step 6
Click OK.
Step 7
On the Comn Properties dialog box, choose the following settings:
Step 8
Click OK.
The Hyperterminal session is now set up.
Step 9
If you are connecting to a JACE-4, open the cover. Otherwise, skip to the next step.
Step 10
Find the 4-pin connector on the motherboard:
• On the JACE-4—the connector is at the top of the board and is marked
MODE. On some models of JACE-4, this connector is in the top left quadrant
(Figure 2-5), in others, it is in the top right quadrant.
• On the JACE-5—the connector is to the left of RS-232 serial port 1.
Step 11
Connect a jumper to two pins of the connector:
• Bits per Second: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: Hardware