Specifications
Table Of Contents
- About This Document
- Understanding Networking and IP Addressing
- Introduction to Networking
- Networking using IP
- Niagara Considerations
- Additional Information
- Configuration and Troubleshooting Tools
- Connecting on a LAN
- Connecting with Direct Dial
- Connecting to an ISP
- Using Security Technologies
- Configuration Files Used for Communication
- Glossary
- Index
Chapter 2 Configuration and Troubleshooting Tools
Niagara Configuration Tools
Niagara Release 2.3
Niagara Networking & Connectivity Guide Revised: May 22, 2002
2–7
Tip If you do not know the name of the JACE, but do know its IP address, use the
tracert command to determine the name.
Step 4
Press ENTER.
RCMD establishes a session between the remote workstation and the JACE. Each
command you issue is carried out at the command prompt of the JACE-NP. For an
example, see Figure 2-4.
Figure 2-4 RCMD to a JACE-NP with the full version of NT.
Step 5
Exit RCMD in one of the following ways:
• To exit RCMD but leave the Console window open, type: exit
• Close the Console window.
Hyperterminal
Hyperterminal is a Windows communications utility typically used for command line
access to a variety of hosts (such as switches, routers, and firewalls). It requires either
modem access to the device or access via a serial port.