Specifications

Chapter 5 Connecting to an ISP
Configuring Captive ISP on the JACE-4/5
Niagara Release 2.3
Niagara Networking & Connectivity Guide Revised: May 22, 2002
5–13
Use the following steps to configure the JACE-4/5 for captive ISP.
Procedure 5-2 Configuring the JACE-4/5 for direct dialing.
Step 1 Using the Admin Tool, connect to and log into the JACE.
Step 2 Click the Network Settings tab.
Step 3 Click Edit Modem Properties.
The ras.properties file is opened for editing (Figure 5-3).
Figure 5-3 ras.properties file opened for editing.
Miscellaneous Properties
pppDebug false
true
Set to true to see dial-up troubleshooting information. This
information is written to the VxWorks target shell and is accessible
via direct connect (Hyperterminal) or over a LAN connection
(Telnet). See “Troubleshooting Connection Problems,” page 5-19.
modemDebug
false
true
Set to true to see dial-up troubleshooting information. This
information is written to the VxWorks target shell and is accessible
via direct connect (Hyperterminal) or over a LAN connection
(Telnet). See “Troubleshooting Connection Problems,” page 5-19.
Note: Neither of these parameters is listed in the ras.properties file
but you can add them.
rasDebug
Table 5-1 Parameters of the ras.properties file used to configure captive ISP. (continued)
Sec-
tion Parameter
Valid Values and Default
Values (in Bold) Description