Specifications
Table Of Contents
- About This Document
- Understanding Networking and IP Addressing
- Introduction to Networking
- Networking using IP
- Niagara Considerations
- Additional Information
- Configuration and Troubleshooting Tools
- Connecting on a LAN
- Connecting with Direct Dial
- Connecting to an ISP
- Using Security Technologies
- Configuration Files Used for Communication
- Glossary
- Index
Niagara Release 2.3
Revised: May 22, 2002 Niagara Networking & Connectivity Guide
Chapter 4 Connecting with Direct Dial
Using Direct Dial
4–42
Tip This is the same user that you granted dial-in permissions to on the remote
host.
Figure 4-34 Supply user name and password credentials for remote host.
RAS attempts to establish a connection between the modem on your computer and
the modem on the remote host. Wait for the connection to be made.
Step 4
If a Connection Complete dialog box is displayed, click OK to proceed.
Step 5
With the connection made, locate the Dial-Up Networking Monitor on the
taskbar and right-click it.
The DUN monitor is used to check the status of the connection and to discover the
IP address assigned to your machine and that of the remote server.
Step 6
Click Status, then click the Details tab (Figure 4-33).
The Client IP Address field displays the address assigned to your machine for this
connection. The Server IP Address field displays the IP address of the remote
server (make note of this address).