Specifications
Table Of Contents
- About This Document
- Understanding Networking and IP Addressing
- Introduction to Networking
- Networking using IP
- Niagara Considerations
- Additional Information
- Configuration and Troubleshooting Tools
- Connecting on a LAN
- Connecting with Direct Dial
- Connecting to an ISP
- Using Security Technologies
- Configuration Files Used for Communication
- Glossary
- Index
Niagara Release 2.3
Revised: May 22, 2002 Niagara Networking & Connectivity Guide
Chapter 4 Connecting with Direct Dial
Using Direct Dial
4–36
Figure 4-25 Phonebook entry wizard.
Step 5
On the Basic tab (Figure 4-26) of the New Phonebook Entry dialog box, do the
following:
a. Check Use Telephony dialing properties
b. Type the Area code and Phone number of the host you want to dial.
c. Verify that the correct modem is listed in the Dial using section.
Figure 4-26 New phonebook entry Basic tab information.
Step 6
Click the Server tab (Figure 4-27) and do the following:
a. Set Dial-up server type to PPP: Windows NT, Windows 95 Plus, Internet.
b. Check TCP/IP as the Network protocol.
c. Check Enable software compression.
d. Check Enable PPP LCP extensions.