Specifications
Table Of Contents
- About This Document
- Understanding Networking and IP Addressing
- Introduction to Networking
- Networking using IP
- Niagara Considerations
- Additional Information
- Configuration and Troubleshooting Tools
- Connecting on a LAN
- Connecting with Direct Dial
- Connecting to an ISP
- Using Security Technologies
- Configuration Files Used for Communication
- Glossary
- Index
Niagara Release 2.3
Revised: May 22, 2002 Niagara Networking & Connectivity Guide
Chapter 4 Connecting with Direct Dial
Configuring Direct Dial on an Engineering PC
4–30
Figure 4-20 Select device for the incoming connection.
Step 6
In the Virtual Private Network dialog box, click Next.
Note It is not necessary to set up a VPN between direct-dial hosts.
Step 7
In the Allowed Users dialog box (Figure 4-21), click the check box next to any user
who you want to grant permissions to dial into this computer.
Note This is equivalent to granting the user dial-in permissions in the Admin Tool.
Figure 4-21 Grant dial-in permissions.
Step 8
On the Networking Components dialog box, click Internet Protocol and click
Properties (Figure 4-22).