Specifications
Table Of Contents
- About This Document
- Understanding Networking and IP Addressing
- Introduction to Networking
- Networking using IP
- Niagara Considerations
- Additional Information
- Configuration and Troubleshooting Tools
- Connecting on a LAN
- Connecting with Direct Dial
- Connecting to an ISP
- Using Security Technologies
- Configuration Files Used for Communication
- Glossary
- Index
Chapter 4 Connecting with Direct Dial
Configuring Direct Dial on an Engineering PC
Niagara Release 2.3
Niagara Networking & Connectivity Guide Revised: May 22, 2002
4–25
Note In order to start the service, your RAS must be configured and your modem
must be turned on.
Step 3
With Remote Access Server selected, click Startup.
Step 4
Click the radio button next to Automatic, then click OK (see Figure 4-17).
Figure 4-17 Starting RAS.
Step 5
On the Services dialog box, click Close to save your changes.
Granting Dial-in Permissions
If any host is going to connect to RAS on the JACE controller you must grant the
connecting user dial-in permissions. You do this on the Users tab of the Admin tool.
For complete instructions, refer to the “Enabling Dial-in” section on page 4-16.
Configuring Direct Dial on an Engineering PC
Configuring direct dial on an engineering PC (be it a Web Supervisor or a Technician
PC) consists of three major steps:
• Installing and Configuring Modems