Specifications

Table Of Contents
Niagara Release 2.3
Revised: May 22, 2002 Niagara Networking & Connectivity Guide
Chapter 4 Connecting with Direct Dial
Configuring Direct Dial on the JACE-NP
4–24
Figure 4-16 RAS Server TCP/IP dialog box.
Step 12
To save your changes:
a. On the RAS Server TCP/IP Configuration dialog box, click OK.
b. On the Network Configuration dialog box, click OK.
c. On the Remote Access Setup dialog box, click Continue.
d. On the Network dialog box, click Close.
The Windows NT setup wizard finalizes the set up of the service.
Starting RAS Once RAS has been configured on the JACE controller, the service needs to be
started, then configured to start automatically each time the JACE controller is
restarted.
Procedure 4-6 Starting RAS.
Step 1
In the Windows Control Panel, double-click the Services icon.
A list of installed services appears.
Step 2
In the Services dialog box, scroll down and click Remote Access Server, then click
Start.
Verify that the service starts successfully (the status changes to Started).