Specifications
Table Of Contents
- About This Document
- Understanding Networking and IP Addressing
- Introduction to Networking
- Networking using IP
- Niagara Considerations
- Additional Information
- Configuration and Troubleshooting Tools
- Connecting on a LAN
- Connecting with Direct Dial
- Connecting to an ISP
- Using Security Technologies
- Configuration Files Used for Communication
- Glossary
- Index
Niagara Release 2.3
Revised: May 22, 2002 Niagara Networking & Connectivity Guide
Chapter 4 Connecting with Direct Dial
Configuring Direct Dial on the JACE-NP
4–22
Figure 4-13 Add RAS Device dialog box.
c. In the Remote Access Setup dialog box (Figure 4-12), choose your modem
and click Configure.
Step 7
On the Configure Port Usage dialog box (Figure 4-14), ensure that your modem is
set up to Dial out and Receive calls, then click OK.
Selecting both dial-out and dial-in capability allows the JACE controller to be
accessed from a remote client as well as dial out to a Web Supervisor for the purpose
of archiving alarms and trend data.
Note In Windows NT Embedded only one port can receive calls. If you are adding
an additional modem and want it to receive calls, change the pre-configured
modem to dial out only.
Figure 4-14 Configure Port Usage dialog box.
Step 8
On the Remote Access Setup dialog box (Figure 4-12), click Network.
Step 9
In the Network Configuration dialog box (Figure 4-15), configure the following
settings:
• Ensure that TCP/IP is checked in both the Dial out Protocols and Server
Settings sections.
• In the Encryption settings section, click Require encrypted authentication.