Specifications
Table Of Contents
- About This Document
- Understanding Networking and IP Addressing
- Introduction to Networking
- Networking using IP
- Niagara Considerations
- Additional Information
- Configuration and Troubleshooting Tools
- Connecting on a LAN
- Connecting with Direct Dial
- Connecting to an ISP
- Using Security Technologies
- Configuration Files Used for Communication
- Glossary
- Index
Chapter 4 Connecting with Direct Dial
Configuring Direct Dial on the JACE-NP
Niagara Release 2.3
Niagara Networking & Connectivity Guide Revised: May 22, 2002
4–21
Figure 4-11 RAS properties.
Figure 4-12 Remote Access Setup dialog box.
Step 6
If your modem is listed in the dialog box, click Configure. Otherwise, do the
following to add your modem:
a. Click Add.
b. In the Add RAS Device dialog box (Figure 4-13), click OK. Your modem is
added to RAS and is now available to set up.