Instructions

The batteries should be inserted into the third outside transmitter at the latest within
10 seconds after reception of outside area data from the second outside transmitter.
8. Toensureasufcient868MHzsignaltransmission,itisnecessarytomaintainadistanceof
nomorethan100metersundergoodconditionsbetweenthenalinstallationlocationsof
the weather station and the outside transmitter (see note under “Placement” and “868 MHz
reception”).
If the description above for setting of additional outside transmitters is not correctly
followed, transmission problems can arise. If such problems arise, removal of the
batteries from all units and a new setting from Step 1 are required.
Ifthebatteryoutputisinsufcient,abatterystatussymbolisdisplayed.Thebatterysymbolinthe
“Indoor” area (upper right) indicates that the batteries of the weather station should be replaced;
the battery symbol in the “Outdoor” area (lower right) applies to outside transmitter.
b) Adjustment of the temperature unit
The temperature display is preset to °C (Celsius) units.
1. To switch the display to °F (Fahrenheit), push and hold the SET/CH key
for about 3 seconds to enter manual setting mode; the temperature display
°C/°Fashes.
2. Whenthedisplayashes,usethe+keytoswitchbetween“°F”and“°C.”
3. PresstheSET/CHkeytoconrmtheselectionandtoenterthe“Setting12/24-hourdisplay
format” mode.
c) Setting time display format (12/24-hour)
1. “12h”or“24h”willashontheLCdisplay(default24h).
2. Use the “+” - key to set the display mode to “12h” or “24h.”
3. PresstheSET/CHkeyagaintoconrmtheselectionandto
enter the “Manual time setting” mode.
d) Time setting
1. PressingtheSET/CHkeyagainmakesthehourguresash.
2. Use the “+” key for setting the hours.
3. Then press the SET key in order to get into the setting
modefortheminutes;theminuteguresash.Usethe
“+” key for setting the minutes.
28