User manual

41
 Becarefulnottoshort-circuittheinputandoutputlines.Keepthe
wiresseparate.
• Use the device as a template and
mark the locations for the bore-
holeonthewall.Todothisusethe
mounting holes in the rear panel
suitablefor yourmountingposition.
Theholeschosenshouldbelocated
oppositeeachothertoensuremaxi-
mum stability.
• Usea6mmdrillandboreatleast30mmdeepatthemarks.
 Notethat,dependingonthesubstrate,otherfasteningmaterialthan
the material in the installation kit .enclosed may be required. Use
thetypeofinstallationdependingontheconditions.
• Presstheanchorsinuntiltheyfullydisappearintothewall.
• Feed the cable through the relay
part and secure to the wall with
screws. Tighten the screws well.
The“UP”arrowshouldpointtothe
ceiling.
• Make sure that the cable in the
deviceremains exible. Installthe
clamping mechanism again and
tighten the two screws.
• Cut the strands into length and re-
move the insulation 6 - 7 mm from
the ends. Do not damage the wires.