User manual

40
7. Assembly
Theroomthermostatconsistsoftwo
partsthat areheldtogether by clips.
Theswitching logic with temperature
sensor, display and control panel is
inthefrontpart.Thesupplybatteries
(2xAA1.5V,notincluded)areplaced
inside this part.Always changeboth
batteries and replace them with two
new batteries of same size, brand,
typeandage.
Pleasepayattentiontothecorrectpolarity(plus/+andminus/-)wheninserting
the batteries.
Separatethepartsbycarefullyopeningtheclipsinthewall-mountedpartand
detachingthefrontpartwithlogicanddisplay.Youndtheclipsinthemidstat
theleftandright.Pressbelowtheclipsandpullonthefrontpartoftheroom
thermostat.
Checkwhethertheplacewhereyouintendtoinstallthethermostathaswires
andcablesunderitssurface.Thesecangetdamagedbydrilling.
Switch off the main switch and secure against being switched on
again. Check that the wires are volt-free.
Remove the terminal block on the
rearoftherelaypartandthecoverof
the screw contacts. Route the cables
(fromtherear)throughtheopening
oftherelaypartbehindit.The“UP”
arrowshouldpointtotheceiling.
UP