Operation Manual

47
Toseparatethehousingparts,carefullyremovetheclipstodetachthefrontpart
(withelectronicparts/display).Youndbothclipsinthemiddleattheleftand
rightofthehousing.Pushdownthehousingcarefullybelowtheclipsandpullthe
frontpartoftheroomthermostatuntilbothhousingpartsdetachfromeachother.
• Checkwhethertheplacewhereyouintendtoinstallthethermostathaswires
andcablesunderitssurface.Thesecangetdamagedbydrilling.
• Removetheterminalblockonthebottompartofhousingandthecoverof
thescrewcontacts.Routethecables(fromtherear)throughtheopeningof
bottompartofhousingbehindit.The“UP”arrowshouldpointtotheceiling.
• Usethe deviceasa templateand
mark the locations for the borehole
on the wall (alternatively, the thermo-
stat can be installed on a 60 mm in-
wall socket). To do this use the
mounting holes in the rear panel
suitableforyour mounting position.
Theholeschosenshouldbelocated
oppositeeachothertoensuremaxi-
mum stability.
• Usea6mmdrillandboreatleast30mmdeepatthemarks.
 Notethat,dependingonthesubstrate,otherfasteningmaterialthan
the material in the installation kit .enclosed may be required. Use
thetypeofinstallationdependingontheconditions.
• Presstheanchorsinuntiltheyfullydisappearintothewall.