User manual

27
 Becarefulnottoshort-circuittheinputandoutputlines.Keepthewiresseparate.
• Usethedeviceasatemplateandmarkthelocationsfor
theboreholeonthewall.Todothisusethemounting
holesintherearpanelsuitableforyourmountingposi-
tion.Theholeschosenshouldbelocatedoppositeeach
other to ensure maximum stability.
• Usea6mmdrillandboreatleast30mmdeepatthemarks.
 Notethat,dependingonthesubstrate,otherfasteningmaterialthanthematerialinthe
installationkit.enclosedmayberequired.Usethetypeofinstallationdependingonthe
conditions.
• Presstheanchorsinuntiltheyfullydisappearintothewall.
• Feedthecablethroughtherelaypartandsecuretothe
wallwithscrews.Tightenthescrewswell.The“UP”ar-
rowshouldpointtotheceiling.
• Makesurethatthecableinthedeviceremainsexible.
Installtheclampingmechanismagainandtightenthe
two screws.
• Cut the strands into length and remove the insulation
6-7mmfromtheends.Donotdamagethewires.
 Use a cable cross-section for the electrical installation that is suitable for up to 8A
(1 - 2.5 mm
2
).Siliconecoatedcablesarerecommended.Theuseofrigidlinesmaylead
tobrokencables.Useexiblelines.Notall(inexible)linesmusthaveawireendsplice.
Checkthecrimpedcableends.Allwiresofastrandmustbeenclosedinthesplicein
ordertoensurethetotalcablecross-section.Thelengthofthewireendsplicecontact
surface should be 6 - 7 mm.