Certifications 2
Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 1516976
Material Safety Data Sheet
6. Accidental Release Measures
6.1. Personal precautions, protective equipment and emergency procedures
See section 8
6.2. Environmental precautions
See section 12
6.3. Methods and material for containment and cleaning up
Minor Spills
Remove all ignition sources.
Clean up all spills immediately.
Avoid contact with skin and eyes.
Control personal contact with the substance, by using protective equipment.
Major Spills
Do not use compressed air to remove metal dusts from floors, beams or equipment
Vacuum cleaners, of flame-proof design, should be used to minimise dust accumulation.
Use non-sparking handling equipment, tools and natural bristle brushes.
Provide grounding and bonding where necessary to prevent accumulation of static charges during metal dust handling and
transfer operations
Cover and reseal partially empty containers.
If molten:
Contain the flow using dry sand or salt flux as a dam.
All tooling (e.g., shovels or hand tools) and containers which come in contact with molten metal must be preheated or specially
coated, rust free and approved for such use.
Allow the spill to cool before remelting scrap.
Moderate hazard.
CAUTION: Advise personnel in area.
Alert Emergency Services and tell them location and nature of hazard.
Control personal contact by wearing protective clothing.
6.4. Reference to other sections
Personal Protective Equipment advice is contained in Section 8 of the SDS.
Page 8 of 28