Manualshelf

Certifications 2

ManualsBrandsBasetech ManualsDIY & ToolsSoldering station Analogue 40 W Basetech 1516976 150 up to 420 °C
11121314151617181920
Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 1516976
Material Safety Data Sheet
Body protection
See Other protection below
Other protection
Overalls.
P.V.C. apron.
Barrier cream.
Thermal hazards
Not Available
Respiratory protection
Particulate. (AS/NZS 1716 & 1715, EN 143:000 & 149:001, ANSI Z88 or national equivalent)
Required Minimum Protection
Factor
Half-Face Respirator Full-Face Respirator Powered Air Respirator
up to 10 x ES P1
Air-line*
-
-
PAPR-P1
-
up to 50 x ES Air-line** P2 PAPR-P2
up to 100 x ES P3
Air-line*
-
-
100+ x ES Air-line** PAPR-P3
* - Negative pressure demand ** - Continuous flow
A(All classes) = Organic vapours, B AUS or B1 = Acid gasses, B2 = Acid gas or hydrogen cyanide(HCN), B3 = Acid gas or
hydrogen cyanide(HCN), E = Sulfur dioxide(SO2), G = Agricultural chemicals, K = Ammonia(NH3), Hg = Mercury, NO =
Oxides of nitrogen, MB = Methyl bromide, AX = Low boiling point organic compounds(below 65 degC)
Respirators may be necessary when engineering and administrative controls do not adequately prevent exposures.
The decision to use respiratory protection should be based on professional judgment that takes into account toxicity
information, exposure measurement data, and frequency and likelihood of the worker's exposure - ensure users are not
subject to high thermal loads which may result in heat stress or distress due to personal protective equipment (powered,
positive flow, full face apparatus may be an option).
Published occupational exposure limits, where they exist, will assist in determining the adequacy of the selected respiratory
protection. These may be government mandated or vendor recommended.
Certified respirators will be useful for protecting workers from inhalation of particulates when properly selected and fit tested as
part of a complete respiratory protection program.
Use approved positive flow mask if significant quantities of dust becomes airborne.
Try to avoid creating dust conditions.
8.2.3. Environmental exposure controls
See section 12
Page 12 of 28