Certifications 2

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 1516976
Material Safety Data Sheet
Ingredient Original IDLH Revised IDLH
tin Unknown mg/m3 / 400 mg/m3 /
Unknown ppm
25 mg/m3 / 100 mg/m3
copper N.E. mg/m3 / N.E. ppm 100 mg/m3
8.2. Exposure controls
8.2.1. Appropriate engineering controls
Metal dusts must be collected at the source of generation as they are potentially explosive.
Avoid ignition sources.
Good housekeeping practices must be maintained.
Dust accumulation on the floor, ledges and beams can present a risk of ignition, flame propagation and secondary explosions.
8.2.2. Personal protection
Eye and face protection
Safety glasses with side shields.
Chemical goggles.
Contact lenses may pose a special hazard; soft contact lenses may absorb and concentrate irritants. A written policy
document, describing the wearing of lenses or restrictions on use, should be created for each workplace or task.
Skin protection
See Hand protection below
Hands/feet protection
The selection of suitable gloves does not only depend on the material, but also on further marks of quality which vary from
manufacturer to manufacturer. Where
the chemical is a preparation of several substances, the resistance of the glove material can not be calculated in advance and
has therefore to be checked prior to the application.
The exact break through time for substances has to be obtained from the manufacturer of the protective gloves and has to be
observed when making a final choice.
Personal hygiene is a key element of effective hand care.
Protective gloves eg. Leather gloves or gloves with Leather facing
Experience indicates that the following polymers are suitable as glove materials for protection against undissolved, dry solids,
where abrasive particles are not present.
- polychloroprene.
- nitrile rubber.
- butyl rubber.
Page 11 of 28