User manual
Operating controls
1
4
2
5
3
6
7
8
9
10
11
14
12
13
1 Key and lock
2 Viewing window
3 LED indicator light
4 Soap tank lid
5 Soap tank
6 Foam pump
7 Opening for anti-theft screw
8 Fixing holes
9 Battery compartment
10 II / I / OFF switch
11 Discharge stop button
12 IR sensors
13 Discharge nozzle
14 6 V/DC, 800 mA power connector
Mounting
• Pay attention to the “Safety instructions” section.
• Select an appropriate installation location for the soap dispenser. There must be a free space
of at least 40 cm under the soap dispenser. Only install the soap dispenser on a stable
surface. Depending on the surface, suitable screws and dowels must be used.
When drilling mounting holes or tightening screws, ensure that no cables or pipes
(including water pipes) are damaged.
1. Open the soap dispenser housing with the key (1) and fold it down.
2. Remove the soap tank (5) pulling it out forward and set it aside.
Fig. 1 Fig. 2
3. Use the soap dispenser as a template and mark ve drilling holes at the place of installation.
Four of the xing holes (8) are needed to hang the soap dispenser and the fth opening (7)
is intended for the locking screw. Use a level to hang the soap dispenser in a horizontal
position.
4. Now drill ve holes in the marked points and insert the ve dowels supplied. Make sure that
the dowels t ush with the wall without protruding.
5. Insert four of the supplied screws into the drilled holes to hang the soap dispenser and
screw them in using a suitable Phillips screwdriver. Let the screws protrude by several
millimetres to be able to hang the soap dispenser. If the soap dispenser is located in a
public area, insert also the fth supplied screw into the opening for theft protection as an
anti-theft screw (7) and screw it in. Caution! Do not overtighten the screw to prevent
damage to the plastic housing.
7 7
7
Fig. 3 Fig. 4 Fig. 5
6. Open the battery compartment by pushing the lid upwards and insert four 1.5 V batteries of
C/LR14 type, observing the correct polarity shown in the battery compartment. Close the
battery compartment again.
Alternatively, you can connect an appropriate power adapter to the 6 V/DC, 800 mA power
connector (14) at the right side of the soap dispenser. The power adapter is not included in
the delivery. To do this, open the cover piece of the connector and connect the power
adapter to the 6 V/DC, 800 mA output (plug: length 12 mm, inner diameter 2.0 mm, outer
diameter 5.5 mm).
Fig. 6
7. Now put the soap tank back into the soap dispenser.
8. Open the soap tank lid (4) and ll the soap dispenser with a suitable liquid soap. Take care
not to overll the soap dispenser (pay attention to the MAX. mark in the soap tank). You can
always detect the actual soap level through the transparent viewing window. Replace the
lid on the soap tank.
Fig. 7 Fig. 8