User manual

IR remote control

Two IR remote controls are included with the sensor.

HOME If you press this button, the alarm system operates in HOME mode -

magnetic contact surveillance only

AWAY If you press this button, the alarm system operates in AWAY mode -

full surveillance

OFF If you press this button, the alarm system is completely deactivated

PANIC Both the HOME and AWAY buttons function as the alarm system pan-

ic buttons. Press and hold down either of these buttons for two sec-

onds and the alarm will sound, regardless of whether it is activated

or not at that moment.

Note:

Each of the IR remote controls uses four alkaline 1.5 volt coin cells (type: LR44, or A76, or V13GA). As soon as

you notice a reduction in the remote control’s range, you should change the batteries. Unscrew the back of the

remote control and carefully remove the back panel. Insert four new coin cells with the poles correctly aligned,

replace the back panel and screw it back on again.

Batteries must be kept out of the reach of children.

Make sure that the polarity is correct when inserting the batteries.

The batteries must not be short-circuited nor thrown into ﬁre nor reloaded. In these cases,

there is a risk of explosion.

Coding

Each coding contains an eight-digit code. This results in 6,561 possible combinations. The control unit and the

key must have the same code for you to be able to operate the system.