User manual

b) Product
• Never use the product immediately after it has been brought from a cold room into
a warm one. The condensation generated could destroy the product. The plug-in
power supply unit also involves danger to life by electric shock!
• Allow the product to reach room temperature before connecting it to the power
supply and putting it to use. This may take several hours.
• The device must not get wet. It should not be used in the immediate vicinity of bath
tubs, showers, swimming pools or washbasins.
• Never pour any liquids over electrical devices or put objects lled with liquid next
to the device. If liquid or an object does enter the interior of the device, power
down the respective socket (e.g. switch off the circuit breaker) and then unplug
the power adapter from the mains socket. Discontinue use and take the product
to a specialist repair centre.
• Do not cover the device when it is switched on (e.g. with a curtain or blanket),
otherwise it may overheat.
• Do not use the device with a timer switch, separate remote control system or other
similar devices that switch the dehumidier on/off automatically, as this creates a
re hazard if the product is covered or installed incorrectly.
• Do not touch the power adapter if there are any signs of damage, as this may
cause a fatal electric shock! Switch off the mains voltage to the mains socket
to which the power adapter is connected (switch off at the corresponding
circuit breaker or remove the safety fuse, then switch off at the corresponding
RCD protective switch, so that all poles of the mains socket are disconnected).
Then unplug the power adapter from the mains socket. Dispose of the faulty power
adapter in an environmentally friendly way and discontinue use. Replace it with a
power adapter of the same design.
• The mains outlet must be located near to the device and be easily accessible.
• Only use the power adapter that came with the product to power the dehumidier.
• Only connect the power adapter to a normal mains socket connected to the public
supply. Before plugging in the power adapter, check whether the voltage stated on
the power adapter complies with the voltage of your electricity supplier.
• Never connect or disconnect power adapters if your hands are wet.
• Never unplug the power adapter from the mains socket by pulling on the cable;
always use the grips on the plug.
• When setting up the product, make sure that the cable is not pinched, kinked or
damaged by sharp edges.
• Always lay the cables so that nobody can trip over or become entangled in them.
This poses a risk of injury.
• For safety reasons, disconnect the power adapter from the mains socket during
storms.
• Always unplug the power adapter from the mains socket before emptying the tank.
Operating instructions
Dehumidier 22.5 W
Item no. 1465108
Intended use
This product is designed to dehumidify small rooms (less than 15 m²). It features a washable
air inlet lter and automatically turns off when the water tank is full. The dehumidier works
using a thermoelectric Peltier module, making it much quieter than compressor-operated
dehumidiers.
It is intended for indoor use only. Do not use it outdoors.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be damaged.
In addition, improper use can cause hazards such as short circuiting, re, electric shock etc.
Read the instructions carefully and keep them. Make this product available to third parties only
together with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Dehumidier
• Power adapter
• Operating instructions
Up-to-date Operating Instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code
above. Follow the instructions on the website.
Explanation of symbols
The symbol with the lightning in the triangle is used if there is a risk to your health,
e.g. due to an electric shock.
The symbol with the exclamation mark in the triangle is used to indicate important
information in these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on operation.
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the warranty/
guarantee.
a) General information
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts,
moisture, ammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed
if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Consult an expert when in doubt about the operation, safety or connection of the
device.
• Maintenance, modications and repairs are to be performed exclusively by an
expert or at a qualied shop.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
Copyright 2016 by Conrad Electronic SE. *1465108_v2_0716_02_m_mh_4L_(1)
Operating elements
a) Dehumidier (front and back)
1
2
3
4
5
7
6
8
9
10
11
b) Water tank
12
13 14
15
16
1 Protective cover 9 Switch (between the water tank and the
top of the water tank column)
2 Air inlet lter with lter net
3 On/off switch (I / O) 10 Water tank (removable)
4 LED indicator (blue = on / yellow = full) 11 Rubber feet (4x)
5 Water level indicator 12 Water tank lid
6 Dry air outlet 13 Water outlet with plastic plug
7 Carry handle 14 Water inlet
8 Power supply socket 15 Float gauge
16 Water tank container
Operation
• Place the dehumidier (with the rubber feet (11) facing downwards) on a stable, clean, dry
and horizontal surface. To move the dehumidier, use the carry handle (7) on the back.
Please note that the rubber feet may leave marks on certain surfaces.
• Ensure that the dehumidier is turned off. The on/off switch (I / O (3)) must be in the O position.
• Connect the plug on the power adapter cable to the power supply socket (8) on the back of
the dehumidier.
• Plug the power adapter into a suitable mains socket.
• Move the on/off switch to the l position, The LED indicator (4) on the front of the dehumidier
will turn blue (=on) and the dehumidier will start to dehumidify the room. You should be able
to feel a gentle ow of air from the dry air outlet (6).
• After you having nished using the dehumidier, turn it off by moving the on/off switch to the
O position. Unplug the power adapter from the mains socket.
Emptying the water tank
• When the water tank is full (10), the oat gauge (15) will move upwards and activate a
switch (9). The dehumidier will then turn itself off and the LED indicator will turn green (=full).
The dehumidier turns off automatically when there is approx. 500 ml of water in the tank.
• Use the water level indicator to see how much water is left in the tank.
• Move the on/off switch I / O to the O position, then unplug the power adapter and carefully
remove the full water tank. Ensure that you do not spill any water when removing the tank.
• The tank can be emptied using the plastic plug (13) and the water inlet (14). Carefully remove
the plug from the water outlet and then pour the water out of the tank.
The water tank lid (12) is not removable.
• After you have emptied the tank, replace the plug and slide the tank back into the dehumidier
as far as it will go. Ensure that the plug is facing upwards.
Maintenance and cleaning
a) General information
• Always disconnect the product from the power supply before cleaning it.
• Empty the water tank before cleaning the dehumidier.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could
damage the casing or even impair the functioning of the product.
• Use a dry, lint-free cloth to clean the product. Do not press too hard on the housing, as this
can lead to scratch marks.
b) Air inlet lter and dry air outlet
• Before cleaning the air inlet lter with the lter net (2), remove the protective cover (1).
• Then remove the lter net from its holder in front of the air inlet.
• Dust may accumulate on the lter net and air inlet. Remove dust and dirt from the lter net
and air inlet using a soft and clean long-haired brush or a cloth.
- The lter net can be washed in water. Take care not to damage the lter net when cleaning
it.
- Allow the lter net to dry completely.
• Then insert the lter net and the protective cover into their respective positions.
• Use a brush or cloth to clean the air outlet.
- The air outlet grille is not removable.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according
to the relevant statutory regulations. You thus full your statutory obligations and
contribute to the protection of the environment.
Technical data
a) Dehumidier
Input voltage/current ..................... 9 V/DC, 2.5 A
Power consumption ...................... Max. 22.5 W
Dehumidifying capacity ................. Approx. 250 ml/24 h at +30 °C / 80 % RH
Approx. 80 ml/24 h at +13 °C / 80 % RH
Water tank capacity ...................... Approx. 500 ml
Automatic shut-off ......................... At approx. 500 ml
Room size ..................................... < 15 m²
Noise level .................................... < 40 dB
Operating conditions ..................... +20 to +40 °C, 40 – 85 % RH
Storage conditions ........................ +10 to +50 °C, 20 – 85 % RH
Dimensions (W x H x D) ............... 146 x 222 x 135 mm
Weight .......................................... 980 g
b) Power adapter
Input voltage/current ..................... 100 - 240 V/AC, 50/60 Hz, 1 A
Output voltage/current .................. 9 V/DC, 2.5 A
Power adapter and cable length ... Approx. 1.8 m