Instructions

10.1 Programming the master code (programming code)
You need the master code (previously factory code) to access the programming mode. You
always have to enter this code once you have quit the programming mode to e.g. establish new
IDcardsorusercodesormakeothermodicationstotheindividualsettings.
The user numbers / user ID cards / user codes may not be assigned twice. The
system does not accept double assignments and the following display appears: yellow
LED (4) blinks 5 x and the buzzer sounds 5 x.
If previously saved data is deleted, a new user can be saved using the old number.
In case of a wrong entry, press the button “#” or wait 10 seconds to make the new
entry!
If no other button is pressed within the next 10 seconds, the code lock
automatically returns to standby mode. Therefore, make all the following entries
as fast as possible.
• Press the “asterisk” button “ ” on the keypad (6). Now enter the factory code 1234 and
conrmthiswiththe“number”key“#”.Theyellow(4)andthegreen(5)LEDlightupandyou
are in programming mode.
• Now press the key “0” on the keypad (6) and enter a new programming code (master code, at
least4digits,atmost8digits).Thenconrmtheprogrammingofthecodewiththe“number”
key “#” on the keypad (6).
For security reasons, you should not pass this master code on to third parties, as this
serves as authorisation for programming and deleting the ID cards and user codes.
Input: “ ”--- “1” --- “2” --- “3” --- “4” --- “#” --- “0” ---“master code” --- “#”
10.2 Saving ID cards and user codes (output 1)
Please note that the following chapters only refer to saving ID cards and user codes for output 1!
BeforesavingIDCardsorUserCodes,yourstmustassigna4-digitUserNumberfortheID
Cards or User Codes (password).
Successful operation: yellow LED (4) blinks 2 x and the buzzer sounds 2 x as well
Saving ID cards
• On the keypad (6) press the key “1” and now enter a 4-digit User Number of your choice. Then
teach in the user ID card and press the “number” key “#” on the keypad (6).
37