Instructions

Operating elements
A
B
C
C
C
D
A Red synthetic cover
B Case with electronics
C Mounting legs
D Connection cable for 12V/DC
(red = plus/+, black = minus/-)
Installation and connection
Mountthestroboscopeashgunontoanappropriatesurfacebymeansofthethreemountinglegs(C).
Make sure when drilling resp. tightening the screws that no power, gas or water pipes are
damaged!
Do not use force while tightening the screws, as the housing might get damaged.
Usetheproductonlyinindoorlocationsorprotectedoutdoorlocations.Theproductmustnotbesubjected
to mechanical stress. Locate it e.g. under a roof overhang or such.
Connect both connection cables according to the colour marking to the 12V direct current voltage (red
cable = plus/+, black cable = minus/-).
Usee.g.screwclamps.Whenthecableshouldbewelded,useashrinkabletubingforinsulation.
Warning!
Ifthestroboscopeashgunismountedfreelyaccessible,aspecialistshouldseetoit,thatthe
synthetic cover (A) cannot be opened without tools.
Theinsideofthestroboscopeashguncontainshigh-voltageconductingelements,riskofafatal
electric shock!
Alternatively e.g. the synthetic cover could be glued (glue might lead to discolouring!).
Iftheoperatingvoltage(12V/DC)isswitchedon,thestroboscopeashgunproducesapprox.90ashlights
per minute.
Care and cleaning
Theproductdoesnotrequiremaintenance!Thebuilt-inashtubeisnotreplaceable.
Useaclean,dryandsoftclothforcleaning.
Dust can be removed very easily using a clean, soft brush and a vacuum cleaner.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household waste. At
the end of its service life, dispose of the product according to the relevant statutory regulations.
Youthusfullyourstatutoryobligationsandcontributetotheprotectionoftheenvironment.
Technical data
Operating voltage ................................. 12 V/DC
Current consumption ............................ 400 mA
Flash frequency .................................... approx.90ashlightsperminute
Operating temperature ......................... -10 to +50 °C
Operating humidity ............................... max.90%RH(non-condensing)
Dimensions(ØxH) .............................. 105 x 90 mm
Net weight ............................................. approx. 150 g
Gross weight ......................................... approx. 200 g
Operating instructions
Stroboscope ashgun, 12V/DC
Item no. 1852381
Intended use
Thisproductisintendedtobeusedonalocalizedalarminstallationwith12Valarmoutput(powerratingmin.
400mA).Thestroboscopeashgunproducesonactivationapprox.90ashlightsperminute.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product
for purposes other than those described above, the product may be damaged. In addition, improper use can
causehazardssuchasshortcircuiting,re,electricshocketc.Readtheinstructionscarefullyandkeepthem.
Make this product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements.All company names and
product names are trademarks of their respective owners. All rights reserved.
Delivery content
Stroboscopeashgun
Operating instructions
Latest operating instructions
Download the latest operating instructions via the link www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
Explanation of symbols
Thelightningsymbolinsideatriangleisusedwhenthereisapotentialriskofpersonalinjury,
such as electric shock.
An exclamation mark in a triangle indicates important instructions in this operating manual that
absolutely have to be observed.
Thearrowsymbolindicatesspecictipsandadviceonoperation.
Safety instructions
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
Thedeviceisnotatoy.Keepitoutofthereachofchildrenandpets.
Donotleavepackagingmateriallyingaroundcarelessly.Thismaybecomedangerousplaying
material for children.
Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity,
moisture,ammablegases,vapoursandsolvents.
Do not place the product under any mechanical stress.
If it is no longer possible to operate the product safely, take it out of operation and protect it
from any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage
the product.
Also observe the safety and operating instructions of any other devices which are connected
to the product.
When setting up the product, make sure that the cables are neither kinked nor pinched and
no short-circuit is caused.
Only direct current voltage of 12V should be used.
Usetheproductonlyinindoorlocationsorprotectedoutdoorlocations.Theproductshould
not be used in the near vicinity of a bath, swimming pool or a shower.
Never place the product in explosive areas resp. areas with high dust exposure.
Only use the product in a moderate climate, and avoid a tropical environment.
Keeptheproductawayfromstrongmagneticeldsoccurringnearmachines,electricmotors
or loudspeakers.
Theproductmay only beoperatedwhen the syntheticcover(A) is unscrewedrmlyand
completely.
TheproductshouldnotbeusedwithintheHighwayCodearea,itshouldnotbebuiltinto
vehicles.
In commercial and industrial facilities the regulations for the prevention of accidents as laid
down by the professional trade association for electrical equipment and devices need to be
observed.
Electric devices used at schools, training facilities, do-it-yourself and hobby workshops should
not be handled unless supervised by trained, responsible personnel.
Donotlookintotheashlight,riskofeyeinjuries.
Consult an expert when in doubt about operation, safety or connection of the device.
Maintenance,modicationsandrepairsaretobeperformedexclusivelybyanexpertorata
qualiedshop.
If you have questions which remain unanswered by these operating instructions, contact our
technical support service or other technical personnel.
ThisisapublicationbyConradElectronicSE,Klaus-Conrad-Str.1,D-92240Hirschau(www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the
capture in electronic data processing systems require the prior written approval by the editor. Reprinting, also in
part,isprohibited.Thispublicationrepresentthetechnicalstatusatthetimeofprinting.
Copyright 2018 by Conrad Electronic SE. *1852381_V2_1118_02_mxs_m_en