Instructions

10.5.2 Programming ID Cards to “OUTPUT 1” (E)

To carry out this programming step the code lock should now be in programming

mode (see Chapter “10.1 Entering Programming Mode”).

To programme an ID Card to the relay output “OUTPUT 1” (E) enter the following key

combination:

1 4 digit user number Now hold the ID card up to the “card reader” (5). #

Example:

1 1112 The card to be programmed in is held up to the

“card reader” (5)

10.5.3 Programming User Code to “OUTPUT 1” (E)

To carry out this programming step the code lock should now be in programming

mode (see Chapter “10.1 Entering Programming Mode”).

To programme a user code to the relay output “OUTPUT 1” (E) enter the following key

combination:

1 4 digit user number 4-8 digit user code #

Example:

1 1113 9876 #

Saving user codes

On the keypad (7) press the key “1” and now enter a 4-digit user number and a 4 to 8-digit user

code. Press the “number” key “#” - the green LED (4) blinks. Press the “number” key “#” again

andthegreenLED(4)stopsblinking.Yourentryisconrmed.

If you want to save several codes, you do not have to press the “number” key

“#” again after the second time. Save the individual codes as described above

and press the “number” key “#” after the last entry. This saves all previous

entries as well.

Input:

“1” --- “4-digit user number” --- “4 to 8-digit user code” --- “#” --- “#”