Instructions

F G H I

N.C. COM N.O.

OUTPUT 2

DOOR

SENS GND

ALM

OUT

KEY

ACT

Connection terminal 2

Also be sure to note the example connection plans in these instructions when

connecting the device. These are located on the last page of these instructions.

A = TAMPER

This is the tamper switch output for the connection of an external alarm system.

H = High Potential, L = Low Potential, (N.C. contact)

B = Door bell connection (N.O. contact)

C = N.O. EG GND

Is for connection of an egress button

D = Operating voltage connection (12 V/DC)

E = OUTPUT 1

This is relay output 1, which has a variable contact (N.O. and N.C.).

F = OUTPUT 2

This is relay output 2, which has a variable contact (N.O. and N.C.).

G = “DOOR SENS” connection clamp

The “DOOR SENS” + “GND” allow you to connect a magnet contact or similar.

H = “ALM OUT” connection clamp

This is an alarm output for attaching, for example, an acoustic or optical signalling

device. This output delivers ground/earth potential as soon as it is activated.

I = “KEY ACT” connection clamp

Allows connection of an acoustic or optical signalling device. This output delivers

ground/earth potential as soon as it is activated.