Instructions
Operating instructions
USB2.0 Video-Grabber “BR116”
Item no. 1168633
Version 12/18
°
Intended use
The product is intended to be connected to a USB port of a computer for digitising an analogue
AV signal (FBAS/SVideo signal and stereo-audio signal).
This product complies with the applicable national and European requirements. All names of
companies and products are the trademarks of the respective owner. All rights reserved.
Contents
• Video grabber with connection cable
• CD
• Operating instructions
Safety instructions
The warranty will be void in the event of damage caused by failure to observe
these safety instructions! We do not assume any liability for any consequen-
tial damage!
Nor do we assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions! In such cases,
the warranty will be null and void.
• The unauthorised conversion and/or modication of the product is not permitted for
safety and approval reasons. Do not open/disassemble!
• The product is not a toy and should be kept out of the reach of children.
• The product must not get damp or wet.
• Do not leave packaging material carelessly lying around, since it could become a
dangerous plaything for children.
• Handle the product with care, it can be damaged by impacts, blows, or accidental
drops, even from a low height.
Connection and software installation
• Launch the operating system (Windows XP or higher) and wait until it is fully loaded.
• Plug the Video Grabber into a free USB 2.0 port on the computer (alternatively to a USB 3.0
port). Once connected to the computer, Windows will detect new hardware and will install the
required driver for the Video Grabber automatically.
• Insert the enclosed CD into the appropriate drive of your computer. If the installer does not
start automatically, run it manually. At the time of writing these operating instructions, you
had to run the program “Autorun.exe” from the main directory on the CD. On the screen
that appears click “Install VHS To DVD” to install the video digitizing software and follow the
instructions provided by the software.
• Start the software.
When you start the software for the rst time, you have to enter the registration code,
which you will nd on the back of the CD cover.
• Connect an AV source to the 3 RCA sockets (the yellow is for the video signal, the other two
for the audio signal). Alternatively, you could use the SVideo connector for the video signal
and the red/white RCA connector for the audio signal.
Tips and information
• Only use a USB 2.0 port otherwise there could be gaps and shakes in the video record.
Alternatively, you could also use an USB 3.0 port.
• On the CD you will nd the English language manufacturer’s directions for the software. To
view this you need a program that can open a PDF le (for example Acrobat Reader, which
can be downloaded for free at www.adobe.com).
Disposal
Dispose of the unserviceable product according to the relevant statutory regulations!
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent
the technical status at the time of printing.
© Copyright 2018 by Conrad Electronic SE.