Instructions

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2017 by Conrad Electronic SE. *1528596_V1_0217_02_IPL_m_en
• Turn the potentiometer in such a way, that the arrow points at SET position.
SET
MIN
(RC Trailing) (RL Leading)
MAX
• Press and hold the button for at least 3 seconds. The light ashes briey.
3 sec
• Turn the potentiometer in such a way, that the arrow points at the desired operating mode.
SET
MIN
(RC Trailing) (RL Leading)
MAX
• Press the button briey to conrm.
If you have adjusted the dimming range previously, that setting will be reset.
b) Dimming range
• Turn the potentiometer in such a way, that the arrow points at MAX position.
SET
MIN
(RC Trailing) (RL Leading)
MAX
• Press and hold the button for at least 3 seconds. The light ashes briey.
3 sec
• Turn the drive pin, until the desired maximum brightness is achieved.
• Press the button briey to conrm.
• Adjust the minimum brightness (arrow at MIN position) according to the same principle.
Operation
• Turning on and off: Press the switch
• Dimming: Turn the switch
Hints
• Change the operating mode, if the light ickers continuously or if the dimming range is very
small.
• Change the dimming range, if the light ickers at minimum/maximum brightness setting.
• In case of overload, short circuit or overheating, the light turns off automatically.
Disposal
Electronic devices are recyclable waste and must not be disposed of in household
waste. Always dispose of the product according to the relevant statutory regulations.
You thus full your statutory obligations and contribute to the protection of the
environment.
Technical data
Operating voltage ......................... 230 V/AC, 50 Hz
Rated power ................................. 25 - 400 W (incandescent, halogen)
4 - 100 W (LED lamp)
Installation depth .......................... min. 35 mm
Operating/storage conditions ........ 0 to +50 °C, <90 % RH
Dimensions (W x H x D) ............... 82 x 82 x 50 mm
Weight .......................................... 80 g