User manual

20
8. Installation
• Chooseasuitableinstallationspot.
• Pull apart the air outlet hose by pulling slightly on both ends.
• Screw both adapters clockwise onto the ends of the air outlet hose.
• Place the window mount into the window. The circular opening must face inward.
The window mount is designed exclusively for use with sliding windows (horizontal + vertical).
The length of the window mount is min. 67.5 cm and max. 123 cm.
• Closethewindowasfaraspossibletofastenthewindowmount.
• Install the air outlet hose adapter (5) on the back of the product. The oblong bracket on the left side of the adapter
tsintotheoblongopening.Slidetheadapterdowntosecuretheconnection.
• Pull apart the air outlet hose to the required length.
Guide the exhaust hose as straight as possible during installation. Do not bend the exhaust hose.
• Attach the other end of the air outlet hose to the opening on the window mount. The adapter clicks into place.
 Youmayalsoguidetheexhausthosethroughthewindowwithoutusingawindowmount.Closethewindow
as tight as possible. Make sure not to squeeze the hose or hence damaging it.
9. Remote control
• Removethebatterycompartmentlid.
• Insert 2 AAA batteries and heed correct polarity. Heed correct polarity as indicated in the battery compartment.
• Closethebatterycompartment.
 Changethebatterieswhentheproductnolongerrespondstocommandsfromtheremotecontrol.
 AlwayspointtheremotecontrolattheIRreceiverbelowthedisplay.
The button with no label has no function.