User manual

ManualsBrandsBASETECH ManualsKitchen AppliancesInduction hob Timer fuction Induktionskochplatte

Overheat protection

The heating plate will turn off automatically if the pan becomes too hot and an alarm will sound. Wait for a

few minutes until the pan and the hob have cooled down before turning the hob back on. It is normal for the

heating plate to become warm during use. Caution! Do not touch the hot surface of the hob.

Troubleshooting and error messages

Error message Cause Possible solution

E0 The pan is not suitable (no magnetic

bottom, diameter is smaller than 12 cm),

or there is no pan on the ceramic

heating plate.

Use a suitable pan. For more

information, see "Suitable pans".

E1 The mains voltage is less than 85 V. Check the mains connection when

the voltage returns to normal.

E2 The mains voltage is above 275 V. Connect the hob to a standard

earthed 230 V socket.

E3 The hob is faulty, or the heat sensor is

shorted or not connected properly.

Please contact customer service for

assistance.

E4 The hob is faulty, or the heat sensor

(IGBT) is shorted or not connected

properly.

Wait for a minute and then try again.

Please contact customer service for

assistance.

E5 The temperature of the hob surface is

too high (more than 260 °C).

Turn off the hob, unplug the mains

cable and leave the hob to cool

down. If this happens repeatedly,

please contact customer service for

assistance.

E6 The temperature of the heat sensor is

too high (more than 105 °C).

Remove any objects that are

blocking the air vents or fan. If the

fan does not move when the hob

is switched on, take the hob to a

specialist repair centre.

Maintenance and cleaning

• Before cleaning the hob, unplug the mains cable and leave the hob to cool down.

• Do not pour liquids over the hob or submerge it under water.

• Always disconnect the hob from the mains before cleaning it.

• Never use aggressive detergents, rubbing alcohol or other chemical solutions (e.g. thinners or benzene),

as these could damage the casing or even impair the functioning of the product.

• Use a lint-free cloth soaked in water and washing-up liquid to clean the exterior of the hob.

• Wipe off food residue using a damp cloth and a small amount of washing-up liquid. If necessary, use a

cooktop scraper.to remove stubborn residue.

• Clean the product from time to time using a special cleaning agent.

• Use a vacuum cleaner to remove dust and uff from the air vents.

Disposal

Electronic devices are recyclable waste and must not be disposed of in the household waste. At

the end of its service life, dispose of the product according to the relevant statutory regulations.

You thus full your statutory obligations and contribute to the protection of the environment.

Technical data

Operating voltage .................................230 V/AC, 50 Hz

Power settings ...................................... 8 settings from 200 - 2000 W

Temperature settings ............................8 settings from 80 - 240 °C

Operating/storage conditions ................ -30 to +45 °C, 0 - 90 % relative humidity (non-condensing)

Dimensions (W x H x D) ....................... 380 x 280 x 60 mm

Weight .................................................. 2.3 kg

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in

electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.

This publication represent the technical status at the time of printing.