Certifications 2

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 588251
Material Safety Data Sheet
Page 3 of 7
6. Accidental Release Measures
Procedures for Cleanup:
Material is recyclable. Control source of spillage if possible to do so safely. Clean up spilled material immediately, observing
precautions in Section 8, Personal Protection. Molten metal should be allowed to solidify before cleanup. Once solidified, wear
gloves, pick up and return to process. Powder or dust should be cleaned up using methods that will minimize dust generation
(e.g., vacuum solids.). Return uncontaminated spilled material to the process if possible. Place contaminated material in
suitable labelled containers for later recovery or disposal. Treat or dispose of waste material in accordance with all local,
regional, and national requirements.
Personal Precautions:
Persons responding to an accidental release should wear protective clothing, gloves and a respirator (see also Section 8).
Close-fitting safety goggles may be necessary in some circumstances to prevent eye contact with dust and fume. Where
molten metal is involved, wear heat-resistant gloves and suitable clothing for protection from radiant heat and hotmetal splash
as well as a respirator to protect against inhalation of fumes.
Environmental Precautions:
In the event of a major spill, prevent spillage from entering drains or water courses.
7. Handling And Storage
Precautions for Safe Handling:
Use of safe work practices are recommended to avoid eye or skin contact and inhalation of fumes during soldering operations.
Use only with adequate ventilation.
Food, beverages and tobacco products should not be stored or consumed where this material is in use. Always wash hands
before smoking, eating, drinking or using the toilet. Wash contaminated clothing and other protective equipment before storage
or re-use.
Provide eyewash fountains and safety showers in close proximity to points of potential exposure.
Conditions for Safe Storage:
Store in a dry, well ventilated area. Keep material dry. Prevent dust accumulation. Keep away from incompatible materials.