Instructions

22
• Wear a dust protection when working on:
- lead from lead-based paint
- crystalline silica from bricks and cement and other masonry products
- arsenic and chromium from chemically-treated lumber
Inhalation of these harmful/toxic dusts can endanger the health of the operator and bystanders. The
risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated area, and work with approved personal protective
equipment (PPE), such as dust masks that are specially designed to lter out microscopic particles.
6. Operating elements
(Ú Fold-out page)
1 0/1 switch (On/Off)
2 Battery compartment
3 Speed control dial
4 Ventilation openings
5 Accessory bracket
6 Washer
7 Fixing screw
8 Hexagon key
7. Setup and preparation
Switch the product off and remove battery pack before assembly, cleaning, adjustments, maintenance,
storage and transportation.
Always wear gloves when handling with the product.
a) Assembling/changing the accessory
This product incorporates a built-in standardised Oscillating Interface System (OIS) intake for third-party
accessories. Accessories with other adaptors are not compatible with this product. When purchasing third-
party accessories, look for OIS indication on the packaging.
1. Remove the battery pack from the product (if already installed).
2. Loosen the xing screw (7) from the accessory bracket (5) with the hexagon key (8). Remove the washer (6).
3. Place the accessory on the accessory bracket. The openings on the accessory must t onto the pins of the
accessory bracket.
4. Replace the washer and rmly tighten the xing screw with the hexagon key.