Instructions / Assembly

FCC Guidelines
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harml interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harml interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harml
interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for
help.
• Contains FCC ID: 2AC7Z-ESP32WROOM32E
• To satis FCC RF Exposure requirements for mobile and base
station transmission devices, a separation distance of 20 cm or
more should be maintained between the antenna of this device
and persons during operation. To ensure compliance, operation
at closer than this distance is not recommended. The antenna(s)
used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Additionally, For Canada:
• This device complies with Industry Canada license- exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
• Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes: (1) l’appareil ne
doit pas produire de brouillage, et (2) l’utilisateur de l’appareil
doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
• Contains transmitter module IC: ESP32-WROOM-32E
Troubleshooting guide
Problem Solution
WiFi light is solid
red
Check your router and internet connection.
Then, power cycle the module. Unplug the
module from the wall and disconnect from
the battery. Let it sit for a minute and then
reconnect both power sources.
Press the Reset button with a paper clip and
restart the setup process.
The red/green
lights keep
alternating
aer the setup
process
Press the Reset button with a paper clip and
restart the setup process.
Server light is
solid red
Communication error. Power cycle the
module. Unplug the module from the wall
and disconnect from the battery. Let it sit
for a minute and then reconnect both power
sources. If Server light is still red in 24
hours, call Glentronics support at 800-991-
0466.
6