Instructions / Assembly
WiFi Module Status: This describes the state of the connection
between the module and the router.
(a) The WiFi Module is designed to check in with our server
every 5 minutes. If the module misses 3 consecutive
check-ins (aer 15 minutes) the status will change from
‘connected’ to ‘connection is lost’. The unit could be
losing connection for a variety of reasons, such as a weak
Internet connection or loss of power.
Note: When a notication changes, you will see that change on the
page within approximately 30 seconds.
(11) Explanation of the lights
This section will explain what the lights on the WiFi module mean.
11-1. Alternating red and green (WiFi and Server) lights:
(a) The module is ready for set up
11-2. WiFi light:
(a) Solid green = module is connected to the router
(b) Solid red = module has lost connection to the router
(c) Rapid blinking green = the module is in the process of
sending a message
11-3. Server light:
(a) Solid green = connected with Glentronics server
(b) Solid red = connection with Glentronics server lost
(12) Resetting the module & troubleshooting
This section explains how to clear the module if it is changing
ownership.
12-1. If the module is changing hands or you are moving
and leaving it for the new homeowners, you should reset the
unit to avoid receive notications from that unit.
(a) Using a paperclip, press and hold the reset button on the
WiFi module for approximately 5 seconds.
(b) This will cause the LEDs to alternate again. Leave it in
this mode.
(c) The next user will register the module to their email
address.
Warning
Changes or modications not expressly approved by Glentronics
could void the user’s authority to operate the equipment.
5