Instruction Manual

ManualsBrandsBASELINE ManualsEquipmentMotorcycle Ready Addendum

READ these instructions before placing unit in

service. KEEP these and other materials delivered

with the unit in a binder near the machine for ease

of reference by supervisors and operators.

Operation Instructions

1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 615/641-7533 800/688/6359 www.ammcoats.com Manual Part No.: 85608968 00

HENNESSY INDUSTRIES INC. Manufacturer of AMMCO

, COATS

and BADA

Automotive Service Equipment and Tools. Revision: 07/13

This is a supplement to your operating manual and covers additional

operational procedures available for this model. If you do not have your

original operating manual, please call COATS at 1-800-688-6359 to

request an additional copy.

200MC/400MC

Rim Clamp

Tire Changer

For servicing motorcycle and ATV tire/wheel assemblies.

Summary of content (8 pages)

PAGE 1
200MC/400MC Rim Clamp® Tire Changer ORCYC T L O E M For servicing motorcycle and ATV tire/wheel assemblies. R E A DY This is a supplement to your operating manual and covers additional operational procedures available for this model. If you do not have your original operating manual, please call COATS at 1-800-688-6359 to request an additional copy. Operation Instructions READ these instructions before placing unit in service.
PAGE 2
• BaseLine
PAGE 3
Operating Instructions The unit must be properly operated and properly maintained to help avoid accidents that could damage the unit and injure the operator or bystanders. This section of the Operating Instructions manual review basic operations and use of controls. These instructions should be reviewed with all employees before they are allowed to work with the machine. Keep these instructions near the machine for easy reference.
PAGE 4
5a. Prior to placing the wheel on the table top to clamp, observe the style and strength of the wheel and adjust the clamp pressure as necessary using the pressure regulator and gauge. Thin spun aluminum rims sometimes used on ATV and motorcycle are sometimes delicate and a reduced air pressure should be considered verses cast aluminum and steel wheels that can support more clamping force. 5b. Next, observe the rim size from the tire, i.e. 15, 16, 17, etc.
PAGE 5
NOTE: Push down on the tire across from the demount tool during table top rotation to utilize the drop center area of the wheel. This reduces the tensional force on the bead during demount. 1/8" to 3/16" 1/8" to 1/4" Figure 8 - Proper Mount/Demount Tool Position 13. Lift and hold the tire at an angle so that the lower bead is resting in the drop center directly across from the demount tool, and is loose below the demount tool (Figure 11).
PAGE 6
Tire Mounting This information must be read and followed carefully to prevent accidents and injuries during mounting. WARNING 2. Inspect tire for damage, paying close attention to the beads. Verify size match between tire and wheel (Figure 12). 3. Lubricate tire beads liberally with tire manufacturer approved lubricant (Figure 13). Check tire and wheel carefully before mounting. Make sure the tire bead diameter and wheel diameter match exactly.
PAGE 7
WARNING Do not force the tire onto the rim. Bead damage could result making the tire unsafe and/ or creating the risk of injury. NOTE: If table top rotation stalls, reverse the table top momentarily until the tire bead is again loose on the wheel. Reposition the mount tool, make sure the bead is correctly positioned in the drop center of the wheel, then attempt mounting again.