Model: BLMR06 6,000 lb. ( 2721 kg ) Portable MID RISE READ the Manual Thoroughly Before Installing, Operating, Servicing, or Maintaining the Lift SAVE this MANUAL and ALL INSTRUCTIONS 1601 J.P. Hennessy Drive La Vergne, TN 37086 Tel.
Lift Purchase Buyers Agreement Warranty Each product comes with a two (2) year parts warranty with five (5) years warranty on the structure. The parts warranty is limited to defects in workmanship and material. The warranty does not cover misuse, abuse, overloading, lack of maintenance, and inappropriate use or “normal wear and tear”. Warranty parts must be returned to manufacturer for inspection to qualify for warranty. Shipping costs are the owner’s responsibility.
Your new lift will provide years of dependable service if installed, operated and maintained properly. Read and follow all safety, installation, operation, and maintenance instructions in this manual before installing and operating the lift. In addition, read and follow all safety and other information included on and with the lift before operating the lift. Keep this manual in a secure place for future reference, training and service part identification. TABLE of CONTENTS 1. 2. 3. 4. 5. 6.
1. UNLOADING PROCEDURE and LIFT PACKAGE CONTENTS For your information: All lift components are grouped together in one package held at each end by steel frames. Unpacking Procedure: When the lift arrives on site: If possible have the lift unloaded in the installation area. Check for freight damage and report immediately to the trucking company who delivered the lift. Check for missing parts and report immediately to the factory.
2. IMPORTANT SAFETY INSTRUCTIONS When using your garage equipment, basic safety precautions should always be followed, including the following: 1. Read all instructions 2. Do not operate equipment with a damaged cord or if equipment has been dropped or damaged – until it has been examined by a qualified service person 3. To reduce risk of fire, do not operate equipment in the vicinity of open containers of flammable liquids (gasoline) 4.
and lift area and remove all obstructions. Before removing vehicle from the lift or lift area, confirm an unobstructed exit. 10. DO NOT PERFORM ANY MAINTENANCE OR INSTALLATION OF ANY COMPONENTS WITH OUT FIRST ENSURING THAT ELECTRICAL POWER HAS BEEN DISCONNECTED AT THE SOURCE OR PANEL AND CANNOT BE RE-ENERGIZED UNTIL ALL MAINTENANCE AND/OR INSTALLATION PROCEDURES ARE COMPLETED (ANSI 244.1).
3. GENERAL REQUIREMENTS & LIFT SPECIFICATIONS 6,000 (2727 kg) Capacity – 1,500 lbs. Each Lifting Pad Constant supply of 220V or 110V 1PH 60Hz 20A electrical power is required for this lift.
LIFT PROBLEM TROUBLESHOOTING GUIDE The following are some suggestions to consider if problems are encountered with the lift. Please call a Trained Lift Service Person for further clarification and information. Problem Lift Will Not Raise or Lower Possible Causes 1. Blown fuse or circuit breaker 2. Incorrect voltage to motor 3. Bad wiring connections 4. "UP" switch burned out 5. Motor windings burned out Solutions 1. Replace fuse or reset/replace circuit breaker 2. Supply correct voltage to motor 3.
Problem Possible Causes Solutions Slow Drift Down 1. Mechanical safety locks not engaged 2. Powerpack lowering valve contamination 3. Hydraulic system leaks 1. Raise lift to engage all safety locks then lower lift and confirm all safety locks are engaged 2. Back flush powerpack by opening manual over-right valve. Engage "up" switch and down lever at the same time and run approximately 10 seconds 3.
Model: BLMR06 6,000 lb. ( 2721 kg ) Portable MID RISE for installation & service part reference SAVE this MANUAL and ALL INSTRUCTIONS 1601 J.P. Hennessy Drive La Vergne, TN 37086 Tel.
