Product Manual

Step 1 - Box Assembly
Assemble box using using the top (TP), bottom (BP), sides (SP), foot plate (FP), and 8 5/8”
slotted screws and wing nuts.
Begin with the BP on the floor. Line the FP (groove side up) holes with the holes on the front
of the BP. Line both SPs with the holes on the BP. The SPs should be positioned inside the
lips of the FP, TP, and BP. Insert each of the bottom screws from the outside and tighten each
of the wing nuts on the inside.* Position the TP on the top, with the Baseline logo facing right.
The lips should cover the SPs and FP. Insert the screws from the outside and tighten each
of the wing nuts on the inside.*
*A screw driver may be needed to anchor the screw while tightening the wing nuts.
Remove the backing from the
self-adhesive chart (G) and ad-
here it to a side of the box (SP)
so that it is easily read.
Step 2 - Slider Assembly
Insert the channel mount screws
(D) through the holes on the fin-
ger plate (B) as shown in FIG-
URE 3 and put one teflon spacer
(F) through each screw (D).
Place the screws into the chan-
nel on the Top Plate (TP). Insert
another spacer (F) into each screw
under the Top Plate (TP). followed by a spring (E) and then a wing-nuts(A). (See Figures 3
and 4). Hand-tighten wing-nuts.
Adjust tension as needed by tightening /loosening the wing nuts. The slide device provides
adjustable levels of friction.
standard Flexibility Tester (12-1085) Assembly
FIGURE 3
Slide Device Assembly
FIGURE 4
Slide Device
H
J
J
E
F
faces
front of
unit
Slot in
B
Top view
(not shown):
screw
finger plate
spacer
box top
Bottom view:
box top
screw
spacer
spring
wing nut
3