Owner's manual
User Manual and Reference Guide
LUM0024AB Rev A
Signal Alarm Enable
Web Parameter: Signal Enable check box in the SNMPTrap Limits section of the SNMP
page.
Network Type: Both
Default Setting: Disabled
Options: Disabled, Enabled
Description: Enables a trap for the Signal Level the transceiver reports. The trap condition
is present based on the settings in the Signal Alarm Belowparameter.
Tx Rate Alarm Below
Web Parameter: Tx % Rate Below in the SNMPTrap Limits section of the SNMP page.
Network Type: Both
Default Setting: 50
Options: Any percentage between 50 and 100, in increments of 5.
Description: If the Tx Rate Alarm Enabled option is set to Enabled, a trap condition
occurs if the transmit percent goes below the value in this parameter.
Tx Rate Alarm Enable
Web Parameter: Tx % Rate Enable check box in the SNMPTrap Limits section of the SNMP
page.
Network Type: Both
Default Setting: Disabled
Options: Disabled, Enabled
Description: Enables a trap for the transmit percentage of the transceiver. The trap
condition is present based on the settings in the Tx Rate Alarm Below
parameter.
VSWR Alarm Above
Web Parameter: Reflected Power Above in the SNMPTrap Limits section of the SNMP page.
Network Type: Both
Default Setting: 2
Options: Any whole J-Units between 0 and 40, in increments of 2.
Description: If the VSWR Alarm Enabled option is set to Enabled, a trap condition occurs
if the reflected power goes above the value in this parameter.
83