Owner's manual

FGR2-PE Wirelss Data Transceiver
LUM0024AB Rev A
Maximum Packet Size Definition with RF Data Rate of 864 kbps (in bytes)
Max Setting (blank area = not recommended)
Min Setting 0 1 2 3 4 5 6 7 8 9
3 129 149 169 189 209
4 114 134 154 174 194 214
5 119 139 159 179 199 219
6 124 144 164 184 204 224
7 129 149 169 189 209 229
8 114 134 154 174 194 214 234
9 119 139 159 179 199 219 239
Modem Mode
Web Parameter Modem Mode in the Operation Mode section of the Radio Setup page.
Network Type: Both
Default Setting: Endpoint
Options: See below
Description: The Network Type and Modem Mode options designate the method
FreeWave transceivers use to communicate with each other. FreeWave
Ethernet transceivers operate in a Gateway-to-Endpoint configuration. Before
the transceivers can operate together, they must be set up to properly
communicate.
In a standard configuration, the Gateway mode should be used on the end
which will be connected to the LAN. When setting up the transceiver,
remember that a number of parameters are controlled by the settings in the
Gateway. Therefore, deploying the Gateway on the communications end
where it is easier to access is strongly advised
This field is hidden in the configuration Web page when Global Changes are
enabled. For more information, see "Using the MultiPoint Gateway to Change
All Connected Transceivers" on page 21.
Operation Mode Description
Point-to-Point Gateway Designates the transceiver as the Gateway in Point-to-Point mode. The
Gateway may call any or all Endpoints designated in its Call Book.
A quick method of identifying a Gateway is to power the transceiver. Prior
to establishing a communication link with an Endpoint or Repeater, all
three of the Gateway’s lower LEDs (CD, TX, CTS) are solid red.
58