Owner's manual

Table Of Contents
Chapter 1: Introduction 1
Getting to Know Your Plus-Style Transceiver 1
Boot-Up LED Sequence 2
Ethernet Port Conditions 2
Error LED Conditions 3
Com Port LED Conditions 3
Choosing a Location for the Transceivers 3
Choosing Point-to-Point or Point-to-MultiPoint Operation 3
Chapter 2: Setting Up and Programming Transceivers 7
Basic Steps to Programming Plus-Style Transceivers 7
MultiPoint Network Considerations 8
Powering the Transceiver 8
Determining and Setting a Transceiver's IP Address 9
Using HyperTerminal 9
Using Discovery Server 14
Resetting Transceivers to the Factory Default Settings 15
ConfigurationTool Options 16
Reading Plus-Style Transceivers in Tool Suite 18
Accessing Configuration Web Pages 19
Navigating the Web Pages 19
Providing Site Information 20
Using the MultiPoint Gateway to Change All Connected Transceivers 21
Creating User Logins 22
Defining User Groups 22
Adding and Deleting Users 23
Changing User Passwords 24
Upgrading Plus-Style Transceiver Firmware Using TFTPServer 24
Before You Get Started Upgrading Firmware Using the TFTPServer 25
Configuring the TFTP Server 25
Upgrading Firmware Using the Web Configuration Pages 26
Upgrading Plus-Style Firmware Globally 27
Verifying Firmware Upgrades 28
Common Firmware Upgrade Issues and Solutions 28
Chapter 3: IP and Network Communication Settings 31
LUM0024AB Rev A vii