User Manual

Page i

Table of Contents

Section 1 Configuring the Radios ................................................................................. 1

Before You Begin ...................................................................................................................... 1

Overview of the Steps .............................................................................................................. 1

Step 1 – Ask Your Network Administrator for LAN Network Settings ............................................ 2

Step 2 – Complete the Ethernet Radio Configuration Worksheet ................................................. 2

Step 3 – Install the Radio Equipment and Antennas ...................................................................... 2

Step 4 – Verify Radio Communication over the Stand-Alone Network .......................................... 3

Step 5 – Download the Discovery Server Executable to the Laptop Computer ............................. 3

Step 6 – Configure the Settings on the Ethernet Radios ................................................................ 3

Change the Default IP Address to the Static IP Address for the LAN ........................................ 3

Change Additional Radio Settings ............................................................................................ 5

Step 7 – Verify that the Controllers Are Connected to BaseManager ............................................ 6

Section 2 Adding a Repeater ........................................................................................ 7

Overview of the Steps .............................................................................................................. 7

Step 1 – Map Out the Subnet IDs for the Network ........................................................................ 7

Step 2 – Install the Repeater Ethernet Radio at the Site ................................................................ 8

Step 3 – Find the IP Addresses for the Radios ............................................................................... 9

Stand-Alone Network Instructions ........................................................................................... 9

Find the IP Address of the Repeater Ethernet Radio........................................................... 9

Change the Computer’s IP Address to Connect to the Stand-Alone Network ................... 10

Step 4 – Configure the Settings for the Endpoint that is Called through the Repeater................ 10

Step 5 – Configure the Settings for All Other Endpoints in the Network ..................................... 11

Step 6 – Configure the Settings for the Repeater ........................................................................ 12

Step 7 – Configure the Settings for the Gateway ......................................................................... 12

Step 8 – Verify that the Controllers Are Connected to BaseManager .......................................... 13

Section 3 Using the Configuration Web Server ...........................................................15

Connecting to the Configuration Web Server .............................................................................. 15

Ethernet Radio Settings Reference .............................................................................................. 16

IP Setup Settings .................................................................................................................... 16

IP Address / Subnet Mask / Default Gateway Fields ......................................................... 16