User Manual

Ethernet Radio Configuration Guide
Page 20 Section 3 – Using the Configuration Web Server
Save Your Changes
Click the Save/Apply button at the bottom of the web page.
In some cases, the radio may need to be rebooted in order for the changes to take effect. When
the reboot is necessary, the web page displays a message and a link to send the reboot command
to the radio.
Note: If your changes don’t show up in the configuration pages, after clicking the Save/Apply
button and rebooting the Ethernet radio, you might need to power cycle the radio. Unplug the
power connector from the control board. Wait a few seconds and then plug the power connector
back in.
When you have finished making changes to the Ethernet radio configuration, close the browser
window for the FreeWave configuration web page.