Owner's manual

BL-ER-C Ethernet Radio Unit (Gateway/Repeater)
Installation Guide
1-866-294-5847 Rev 8.19.2014 ww.baselinesystems.com
Making the Electrical Connection to the Enclosure
Note: Baseline recommends that you consult or hire a licensed electrician for these
connections.
1. Turn AC power off at the source, and verify that it is off.
2. Remove the screws from the cover of the conduit body, and then remove the cover.
3. Loosen the screw on the grounding lug and route a bare 6 AWG (4.11 mm) earth ground
wire into the grounding lug, and then tighten the screw to secure the ground wire. Do not
overtighten.
4. Connect the enclosure power leads to facility power.
Page 2
Installing the Antenna
If the site survey indicated that the standard antenna mounted on the top of the enclosure
will work at your location, the antenna is installed at the factory. You do not have any further
tasks related to installing the antenna.
If a different antenna is required, refer to the Ethernet Radio Antenna Installation Guide for
instructions.