Manual

BL-ER-X Ethernet Radio Unit for X/XS Cabinet

Installation Guide

1-866-294-5847 Rev 8.19.2014 www.baselinesystems.com

Installing the Ethernet Radio Unit

1. Remove the Ethernet radio unit and the antenna from its packaging.

2. Familiarize yourself with the parts labelled in the illustration below.

3. Inspect the antenna cable connection on the back

of the Ethernet radio unit to ensure that it is securely

connected.

Connued 

IMPORTANT! Make sure the antenna cable remains

securely attached to the connector on the Ethernet

radio. If the radio is powered up with a loose or

disconnected antenna, damage may occur to the

circuitry. This damage is not covered by warranty.

Page 1

PAGE 1
BL-ER-X Ethernet Radio Unit for X/XS Cabinet Installation Guide Installing the Ethernet Radio Unit 1. Remove the Ethernet radio unit and the antenna from its packaging. 2. Familiarize yourself with the parts labelled in the illustration below. 3. Inspect the antenna cable connection on the back of the Ethernet radio unit to ensure that it is securely connected. IMPORTANT! Make sure the antenna cable remains securely attached to the connector on the Ethernet radio.
PAGE 2
BL-ER-X Ethernet Radio Unit for X/XS Cabinet Installation Guide 4. Power down the controller. 5. Use needle-nose pliers to remove the rubber plug from the antenna port on the top of the cabinet. 6. Remove the nut and the lock washer from the bottom of the antenna, and then insert the stem of the antenna into the port on the top of the cabinet. 7. From the inside of the cabinet, place the lock washer on the stem of the antenna, and then thread the nut onto the stem.