User Manual

Page | 97
Graph Not Moving
Characteristics
• The graph shows only a little movement and the ground where the
sensor is located is saturated.
• The overall trend of the graph may be flat but there are sharp peaks that
correspond to the watering cycles. The peaks fall off rapidly.
Recommendation
• The ground is near, at, or above field capacity and does not dry out
between watering days.
• Check the watering frequency. If the system is watering daily or every
two days, increase the days between watering.
• Click the Too Wet button in the Set Sensor section of the Adjustment
and Centering group box below the graph.
• If the problem persists, the sensor may be too deep. It should not be buried any deeper than 4 inches and typically, 2 – 3
inches is an adequate depth for most sensors.