User Manual

ManualsBrandsBaseline Systems ManualsMeasuring instrumentsBACnet Manager

1-866-294-5847 Rev 11.19.2012 www.baselinesystems.com

BL-BMGR-BACNET

BACnet Manager Install Guide

Software Installation

Note: This document applies to BaseManager 1.4.10 only.

1. If your computer already has a version of BaseManager installed

on it, close the BaseManager software before proceeding.

2. Insert the Baseline installation CD into the computer.

3. If prompted, open a Windows Explorer window of the contents of

the CD; otherwise, open a Windows Explorer window and

navigate to the Baseline CD.

4. Read the Readme.txt file to learn about the changes that have

been made in this version of the software—you may also want to

open the PDF version of this file (BACnet Manager Guide.PDF).

5. Install the updated version of BaseManager by clicking the

installation file, BaseMgr-NETInstall-1.4.10.exe. Install in the default

folder and accept other default settings.

Note: You may be asked to restart your computer during this

installation—after the computer restarts, you may have to restart the

installation if it does not automatically continue.

6. Install the BACnet Manager software by clicking the installation

file, BacMgr-NETInstall-1.0.3.exe. This software must be installed in

the default folder (where BaseManager was installed).

Note: This process will install additional drivers. When prompted, install

everything in default locations and with default settings.

Summary of content (4 pages)

PAGE 1
BL-BMGR-BACNET BACnet Manager Install Guide Software Installation Note: This document applies to BaseManager 1.4.10 only. 1. If your computer already has a version of BaseManager installed on it, close the BaseManager software before proceeding. 2. Insert the Baseline installation CD into the computer. 3. If prompted, open a Windows Explorer window of the contents of the CD; otherwise, open a Windows Explorer window and navigate to the Baseline CD. 4. Read the Readme.
PAGE 2
Software Setup—BaseManager 1. When the installation is complete, run the BaseManager application by clicking the desktop shortcut or the menu item under the BaseManager folder in Programs. 2. Configure the Site settings and add BaseStation controllers as needed for normal BaseManager operation. Verify that the BaseManager application can communicate with all 3200 controllers. 3. With BaseManager running, click the Advanced button at the top of the screen to open the Auxiliary Settings window (see below).
PAGE 3
Software Setup—BACnet Manager 1. Run the BACnet Manager application by clicking on the desktop shortcut to the menu item under the BaseManager folder in Programs—Unblock Firewall if prompted. 2. Review the Status tab on the BacManager window and verify that the BaseStation 3200 controllers have been processed. BACnet Objects 1. The BACnet Network Number = 444 2. Connection = BACnet/IP 3. BaseStation 3200 Controller Object Model: a. Accumulator Object—one for each flow device.
PAGE 4
Data Refresh Schedule  The nine alert conditions are refreshed every 15 minutes—this is done by the BaseManager application, which then provides the data to the BACnet Manager application.  The water used data is updated once per day, normally at midnight. 1-866-294-5847 Rev 11.19.2012 www.baselinesystems.