AirWerx 120X Installation & Operations Manual Patent pending Tel: 1-888-641-8862 Web: www.baseaire.com E-mail: sales@baseaire.com Specifications subject to change without notice.
Table of Contents ......................................2 Warranty Registration ..................................................3 Specifications ................................................ 3 How it Works ................................ 3 Installation Requirements ......................................................4 Installation Key Functions................................................ 4 Indicator Lights............................................... 5 ....................
Important Notes · Always connect your dehumidifier using a grounded electrical connection (as required for all electrical appliances). The use of non-grounded wiring will void the warranty. • Your dehumidifier should only be repaired by a qualified technician. • Do not use the dehumidifier in standing water. If there is a chance that the dehumidifier has been flooded, unplug the unit, remove the cover, and allow it to dry completely before proceeding.
Specifications Capacity @ 80°F/60%RH: 120 Pints Per Day Capacity @ 73°F/60%RH: 93 PPD Airflow @ 0.0” SP: 290CFM Operating Temp. Range: 30-105°F Operating Relative Humidity Range: 36%-90% COP: 2.7 L/kWh Refrigerant: R410A Amperage Usage: 7.8 Amps Power Supply: 115V/60Hz/Single Phase Outlet Requirement: 15 Amp Sound Level: 60 dBa Dimensions LxWxH: 13.8” x 15.8” x 23.7” ETL Listed: Yes How It Works AirWerx dehumidifiers use an integrated humidistat to monitor theconditioned space.
Installation 1. Place dehumidifier on a level surface. • Do not place unit directly on vapor barrier. For example, use blocks or pavers to create a level surface. • If unit has been turned or flipped so that the compressor did not remain upright, place the unit on a level surface and wait a minimum of 2 hours before proceeding. 2. Set up the drain line • Remove the compression nut and slide it over the end of the hose to be attached to unit.
· The continuous light will illuminate green and the display will show “CO”. · To switch back to normal humidistat operation, use the arrow keys to move the setpoint above 36%. 4. Manual Drain Button · If you need to store or move your dehumidifier, press the “Drain” button to remove water from the integral pump’s reservoir. 5. Pump Trouble Warning · If the pump reservoir level gets too high, the water sensor will activate to prevent overflow.
Remote Control Instructions AirWerx Dehumidifiers can be controlled using an optional remote accessory. The remote connects to your dehumidifier via a 25’ CAT 5 cable, with the integrated sensor giving you multiple options for monitoring surrounding conditions. Example #1- Install the dehumidifier in the laundry room and duct it into the living room. Mount the remote in the living room and use the remote sensor. Example #2- Install the dehumidifier in your crawl space with the remote mounted in your garage.
Operating Instructions 1. Start the machine • Press the power key to turn the dehumidfier on. 2. Adjust the settings • Use the up and down arrow keys to adjust your desired setpoint (typically 50-55%) 3. Stop the machine • Press the power button again and the dehumidifier will stop. Note that the fan will continue to operate for 1 minute after the unit has shut off. DO NOT DISCONNECT THE POWER CORD TO FORCE THE UNIT TO STOP. 4. Water Drainage · The AirWerx 120X has an integrated condensate pump.
Unit Diagram Control Panel Handle Side Panel Pre-filter Front View Remote Control Discharge Grille Drain Hose Connection Power Cord Ventilation Fan Port (Optional) Auxiliary Terminals Back View 8
Maintenance **For more detailed instructions, visit www.baseaire.com** WARNING: Always unplug the unit before doing any maintenance. Cleaning the Machine Body · Use a soft, damp cloth to clean the exterior of unit. Do not use any soap or solvents. Coil Maintenance · Once per year, clean the coils with an approved coil cleaner. The coil cleaner should be a self-rinsing, foaming, cleaner, such as WEB® Coil Cleaner. Cleaning the Filter 1. Unplug the unit. 2. For PreFilter: a.
Removing the Pump 1. Remove the 9 screws on the side panel and set panel aside. 2. Remove the screw holding the pump in place. 3. Undo the 3 pump electrical quick connects and 1 drain quick connect. 4. Insert a flat head screwdriver into the notch on the side of the pump. This will allow you to gently lift the pump off its reservoir (the reservoir remains attached to the unit). Basic Pump Cleaning Complete about once per year, depending on environment 1.
Dehumidifier Storage If the unit will be stored for an extended period of time, complete the following steps: 1. Turn off the unit and allow it to dry. 2. Complete steps 1-3 in Advanced Pump Cleaning to clean out the pump reservoir. 3. Wrap and secure the power cord. 4. Cover the filter mesh. 5. Store in a clean, dry space. Ducted Applications Ducting the dehumidifier allows the unit to be in one room while conditioning an adjacent room.
Troubleshooting Symptom Cause Solution Poor Connection Verify that both ends of the power cord are plugged in Diaplay is Blank Power Outage Reset power Filter is Dirty No AirFlow Clean the filter Air Inlet or Outlet is Blocked. Clear the blockage Trouble Code: E1 Humidity Sensor or Communication Error Check to ensure that the sensor wire is connected at both ends, if no issues are visible, the sensor may be faulty.
Spare Parts Remote Control W-100 Fan Components Remote Control Assembly (includes W-101 and W-102) W-101 AirWerx Remote Control W-102 AirWerx Remote Control Cable N-802 AirWerx Fan Motor N-804 AirWerx Complete Fan Assembly N-117 Fan Capacitor Filters + External Components Display/Control N-200 AirWerx Prefilter N-100 AirWerx Main Control Board N-201 AirWerx MERV 10 N-101 AirWerx Display Board N-202 AirWerx HEPA N-102 AirWerx RH/Temp.
Limited Warranty All warranty benefits apply to the original owner only. Warranty cannot be transferred or assigned. 1 YEAR ( FROM DATE OF PURCHASE): BaseAire warrants the dehumidifier will operate free of defects in workmanship and materials.
Limited Warranty Exclusions EXCLUSIONS: DAMAGE DUE TO THE FOLLOWING IS NOT COVERED UNDER WARRANTY 1. ACTS OF NATURE- INCLUDING BUT NOT LIMITED TO: ● FLOODING ● FIRE ● WATER DAMAGE ● HURRICANE STORM DAMAGE 2. IMPROPER USAGE-INCLUDING BUT NOT LIMITED TO: ● POOL/SPA/TUB APPLICATIONS ● MISUSE, ABUSE OR TAMPERING WHETHER INTENTIONAL OR ACCIDENTAL ● IMPROPER INSTALLATION OR DESIGN ● MPROPER VOLTAGE ● LACK OF NORMAL CARE ● FAILURE TO FOLLOW INSTRUCTIONS 3. CORROSION 4. FREEZING 5.
Scan QR Code to Register Warranty