User Guide

10
Troubleshooting
SolutionCause
Symptom
Power Supply
Verifythatthereispowertotheoutletand
thattheplugisproperlyinstalledinoutlet.
RoomTemperatureOver
105℉(DisplayHI)orBelow
33℉(DisplayLO)
Theunitidoutsidetheoperating
temperaturerange.Modifytheroom
conditionssothetemperatureisbetween
33°-105℉andoperationwillcommence.
TroubleCode:HIorLO
Cleanthefiltermeshaccordingto
instructionslistedinmanual.
Cleartheblockagefrominletoroutlet.
AirFilterisClogged
AirInletorOutletisBlocked.
MachineWon’tRun
LowAirFlow
TroubleCode:E1
LoudNoise
FilterMeshisBlocked
E1=HumiditySensorIssues
RoomTemperatureOver
105℉orBelow33℉(Display
LO)
MachineIsNotlevel
Movethedehumidifiertoflat,firmground.
Cleanthefiltermeshaccordingto
instructionslistedinmanual.
Checktoensurethatwireisconnectedat
bothends.Ifnoissuesarevisible,the
sensormaybefaulty.
Theunitisoutsidetheoperating
temperaturerange.Modifytheroom
conditionssothetemperatureisbetween
33°-105℉andoperationwillcommence.
Ifroomconditionsarewithintemperature
range,replacethedefectivesensor.
FlexDuctInstallation
Rotatetheflexductcounter-clockwise.
FlexDuctRemoval
Rotateflexductclockwise or remove wire tie.