How to Guide

2
III. HOW TO INSERT THE SOLID DRAIN GRATE
INTO THE TILED SHOWER PAN SO THAT (A) IT
IS SPACED CORRECTLY FOR DRAINAGE AND
(B) IT IS AT THE SAME LEVEL AS THE
ADJACENT TILE: (See Figs. 1 & 3)
1. Select a combination of Vertical Drain
Spacers (2mm, 4mm, and/or 6mm) so that
the top surface of the Solid Drain Grate is
at the same level as the top of the floor
tiles adjacent to the trench.
2. Insert the Rubber Bumpers into the Solid
Drain Grate side holes by inserting them
into the holes until they are locked in place
(Fig. 1).
3. Slide the Solid Drain Grate into the shower
pan Trench Recess, first by compressing
the side of the grate with the Rubber
Bumpers against the wall of the shower
pan Trench Recess (Fig. 3).
4. Finally, slide the other side of the Solid
Drain Grate into the shower pan Trench
Recess.
IV. HOW TO REMOVE THE SOLID DRAIN GRATE
FROM THE TRENCH RECESS: (See Fig. 4)
1. Insert your fingers or an Allen wrench into
the space between the Solid Drain Grate
and the Trench Recess wall (i.e., either
between E and F or between G and H),
carefully lift out one side of the grate and
grab it with both hands and then carefully
remove the other side by lifting the entire
grate with your hands.